Guangzhou SKY Sports Facilities Co.,Ltd
Tel: +86-02037508090E-mail:sales@gzskysports.com
Home > News > Content
EPDM Rubber Particle Square Construction Method
- Dec 28, 2017 -

EPDM rubber particle square construction method

 

EPDM rubber granules are common in our life, especially in some sports, outdoor sports school area EPDM construction has become the hot spot of attention, let's make a brief introduction, hope you put forward valuable opinion!

 

 

Cross the bottom line:

1, the test for the reasonable arrangement of paving work, must be in accordance with the set of solutions on the basis of measuring row line, the entire site into strips, then according to the article according to block paving.

Brush:

2, based upon the acceptance of foundation, in order to strengthen the foundation and the bonding of materials on the surface, on the basis of first blow a layer of special glue mixed with thinner in a certain proportion of mixture, evenly coated with roller stick glue, after being dry start paving at the bottom of the black particles.

3, the bottom paving: with black rubber particles and special glue according to 6.5:1 weight ratio, with a stirring device in the stir zone and use send skip to advance row line, with darby paving, rolling stone roller compaction.

After the bottom solidification, start the noodle stall.

After two to three hours of solidification, once again use roller compaction, uneven ground with trowel to beat flat, such as trowel, roller paste, a little thinner to play a smooth role.

4, surface paving: according to the weight ratio of 4:1 with EPDM granule and special glue, with a stirring device in the stir zone and use send skip to advance row line, with darby paving, with rolling stone roller compaction, pay attention to the compactness, flatness, thickness, rolling over and over again.

After two to three hours of solidification, once again use roller compaction, uneven ground with trowel to beat flat, such as trowel, roller paste, a little thinner to play a smooth role.

5. Measurement of the marking line: draw the course marking line as required.

After the underline, the sports technologie should review.

The linear part is checked by the identified steel tape measure, and after confirming the standard, it can be painted by the prescribed mark.